Richard,
Holes - not normal. Sponges? Normal. Original equipment in the GT.
Bill
Richard Reynolds wrote:
>
> With a bright new torch I was giving my new BGT a thorough examination
> yesterday evening and found that there is a small hole in the exterior where
> the roof gutter meets the horizontal seam of the rear fin. It's an
> identical problem on both sides of the car. Is this a common problem?
>
> The previous owner had stuffed large pieces of foam in the cavity behind the
> C pillar panelling to stop water dripping directly onto the inner wing wheel
> arch, but it wasn't doing a great job and had soaked the sponges. Water was
> running along the seam at the inside top of the fin (though not yet got too
> rusty).
>
> What should I use to block up these holes, and has anyone else found a
> similar problem? I don't suppose the sponges are a very permanent solution,
> but they do help sound insulation from the rear wheels. Does anyone else
> have sponge in here?
>
> Thanks all for your help
>
> Richard
> 66 MGB GT
>
> **********************************************************************
> This email and any files transmitted with it are confidential and
> intended solely for the use of the individual or entity to whom they
> are addressed. If you have received this email in error please notify
> the system manager.
>
> This footnote also confirms that this email message has been swept by
> MIMEsweeper for the presence of computer viruses.
>
> www.mimesweeper.com
> **********************************************************************
|