| To: | mts3@ra.msstate.edu |
|---|---|
| Subject: | Re: MGB Engine removal |
| From: | Jethogger@aol.com |
| Date: | Tue, 16 Nov 1999 10:36:49 EST |
Hello Tyson. You are right about OD mounts. Some tricks I have used to make the job easy to a degree. Make sure the bolt hole are clean. Run a tap up them. Use a shorter bolt. I also use a 1/4 inch drive socket and swivel and extension. This get the bolts started. One more thing. Clean the parts. Good luck. John, Flintstone, GA |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Midget question, Charles D. Sorkin |
|---|---|
| Next by Date: | Re: Synching carbs, Peter C. |
| Previous by Thread: | MGB Engine removal, Tyson Sherman |
| Next by Thread: | Did anyone actually look at Practical Classi, Simon Matthews |
| Indexes: | [Date] [Thread] [Top] [All Lists] |