Plasti-gage
DWADE REINSCH wrote:
>
> Good morning.
>
> I blew out a piston a couple of months ago in my 77 MGB and started this
> morning to put it back together. Here's the problem. The pistons were
> .040 and the rod bearings were .010. This was stamped on the old parts.
> I've got a new set of pistons and rod bearings and so the first thing I did
> was slip one piston down into the engine, with no rings on it, and put on
> the rod cap. When I tightened it up, it I couldn't turn the engine any
> more. It was tight! Any suggestions as to what to try next?
>
> TIA.
>
> dwade
|