David,
Good to hear!
> Questions;
>
> When actually clipping cover, front or back first?
I started front and then clipped the back.
> Finish screw on lower side of seat, any hints on
> lining that up?
I dont remember what I did here, probably took a deep breath and poked
a hole with an awl. I do remember
having to stuff the "pockets" with heavy card to
get the right shape.
The seat back adjustor hole can be tapped with a hammer and this should
mark a square right where you need to cut (actually, I think tapping
cut mostly
through the cover.)
One other tip for final assembly- do NOT put any glue
on the MIDDLE panel of the the seat back cushion or
cover - regardless of what the instructions say.
If you glue the middle, in 6mos time you will have a
wavy seatback with spots where the glue holds and
spots where it doesn't. If you still have the old cover and foam, use
it as a model for where to glue.
The seat bottom cover should be glued to the foam in the center part
ONLY, then folded over the cushion.
Good luck!
--Scott
===
Scott Hower -> howersl@yahoo.com
Bid and sell for free at http://auctions.yahoo.com
|