The bolt is removed..I figuired the shaft was ovaled out to keep the
u-joint and shaft turning together.
My guess is rust is holding the two together. I'll put some WD-40 on it
tonight, and if need be, blue wrench it tomorrow.
I appreicate your help,
Thomas James Pokrefke, III
1970 MGB (minus the interior, temporarily)
pokrefke@netdoor.com
Audentes fortuna iuvat
On Tue, 31 Aug 1999 10:37:57 -0700
Enrique Claure <spaninc@ceibo.entelnet.bo> wrote (and I quote):
> Tom, I did this last week with success. Remember to remove the U joint
> bolts not just loosen them but remove them. They have a groove that lock
> the shaft. Other than that the hole column should slide out. Enrique
|