If you *are* using a 6v coil without a ballast you have probably burnt the
points, hence the poor running. The ballast is a length of resistance wire
of about 1.5 ohms that starts of white at the ignition switch end and
finishes up white/light-green at the coil +ve terminal. From there it is
extended on to a special terminal on the solenoid that only gives out a
voltage during cranking. This boosts the voltage at the coil during
cranking for ease of starting.
I don't think the one-wire alt is standard for any year, it sounds like a
modern after-market jobbie, what do you do for an ignition warning light?
Two- and three-wire alts have one (or two) browns that go to the hot
terminal of the solenoid and the brown/yellow indicator wire. The electric
temp gauges are shown as having a green/blue to the transmitter.
Green is fused ignition and feeds things like instruments, turn signals,
wipers, heater fan etc.
White/black is used between distributor and coil, can't spot a black/white.
PaulH.
http://freespace.virgin.net/paul.hunt1/
or if that doesn't work try
http://194.168.54.52/paul.hunt1
-----Original Message-----
From: Larry Colen <lrcar@red4est.com>
To: Larry Colen <lrcar@red4est.com>; mgs@autox.team.net <mgs@autox.team.net>
Date: 10 August 1999 12:08
Subject: Re: It runs!
>The good news is that it made it the mile into town. I had to stop a
>few times to check out noises, adjust belts etc, but no major problems.
>The bad news is that the drive home wasn't quite so smooth. It died
>on me several times on the drive home. I suspect that it has something
>to do with the ignition.
>
>It's possible that it has a loose wire, but I suspect that I wired
>the ballast resistor in wrong. Can anyone give me a clue as to
>how the ballast should be wired in?
>
>The other wiring questions I have (because no wire colors mathc
>the schematic in the book) are the lone wire that hooks up to the
>alternator and the wire that hooks up to the temp sensor.
>
>The two most likely candidates for either of those are one that is green
>and one that is black and white.
>
>I have a '69 BGT with a 4 lead alternator. Three of the leeds are very
>obvious how they hook up, because they are on one connector, it's the
>fourth lead that is giving me problems.
>
>Pardon the incoherency of this post, but it is 4AM. Sigh, I was hoping
>to actually drive her tomorrow. At least she is running under her own
>power and seems to be fairly strong, from what I can tell babying the
>motor during break in.
>
>--
>"I actually like granola". -Geoff Miller
>lrc@red4est.com http://www.red4est.com/lrc
|