OK, I have some rudimentary engineering background and trying to fill the
tranny of a '76B through the side hole from below is a p***-poor design. I
guess the electronics wizards designed it.
Anyway, I made a squeeze bottle with a tube, but the problem is 5 pints at
1/4th pint per squeeze. That might seem like only 20 squeezes but each
squeeze event took 5-10 minutes because of the inlet tube. I know, make the
tube bigger, but then since the squeeze bottle is limited as well, a new
and different problem arises.
So, does anyone have a really simple design for a device for refilling the
transmission?
BTW, I could not find the 'top' port through the floor so I guess that
might help in some way, but how?
Bill with the tired hands
**********************************************************************
Dr. Bill Saidel
Assoc. Prof. Vocal phone (609) 225-6336
Department of Biology FAX (609) 225-6312
Science Building email: saidel@crab.rutgers.edu
315 Penn St.
Rutgers, the State University of New Jersey
Camden, NJ 08102 -1411
http://crab.rutgers.edu/~saidel/saidel.html
"Between the approximation of the idea and the precision
of reality, there is a small gap of the unimaginable."
Milan Kundera - "The Unbearable Lightness of Being"
|