To: | hjillson@argolink.net, larryhoy@cwix.com |
---|---|
Subject: | Re: torque settings MG was WooHoo - sort of. <G> |
From: | MG4EVR@aol.com |
Date: | Thu, 8 Apr 1999 21:54:43 EDT |
In a message dated 4/8/99 8:38:23 PM, hjillson@argolink.net writes: <<Most likely this would be something like 15" to (15 +1)" or about 1.06 to 1. So for a torque setting of 22 ft/lbs you'd end up with 23.6 ft/lbs or there abouts. Anyway it would be off, but you'd be within a couple of ft/lbs. Harlan. >> yes. it would be assuminmg you ran the crows foot straight out from the torque wrench, but I believe the torque will not change if the crowsfoot is used at less than a 90 degree angle to the handle of the wrench.. Dave 69 MGC/GT |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Movie Review, Lawrie Alexander |
---|---|
Next by Date: | Re: RE: torque settings MG was WooHoo - sort of. <G>, MG4EVR |
Previous by Thread: | Re: torque settings MG was WooHoo - sort of. <G>, Harlan Jillson |
Next by Thread: | Re: RE: torque settings MG was WooHoo - sort of. <G>, MG4EVR |
Indexes: | [Date] [Thread] [Top] [All Lists] |