Hell Lawrie, I may try it your way next time. Er, manual? Whuzzat? ;^)
Uh, ya fergot to tellim to chamfer the stud holes.
Cheers,
Charley
Lawrie Alexander wrote:
>
BIG SNIP!!!
>
> OK, Charley, your turn.....................:-)
>
> Lawrie
> British Sportscar Center
> (who learned from many years of doing, and occasional reference to a
> manual..................)
>
> -----Original Message-----
> From: michael poe <mgbgt74@earthlink.net>
> To: mgs@autox.team.net <mgs@autox.team.net>
> Date: Friday, March 05, 1999 5:38 PM
> Subject: smoking away
>
> >Well, I was out for a nice drive after changing the front wheel bearings
> >last week and decided I would take a trip on the interstate. Everything
> was
> >going fine till I hit a hill doing 70mph and white smoke just went
> >everywhere(including inside the car) so I pulled over and found a nice
> river
> >of antifreeze running down the side of the block. It was coming from the
> >head and block mating area, so I have the new headgasket. I did a little
> >research and the problem only occurs over 65mph going uphill, so I am
> >wondering if the head or block surface area may be warped slightly and
> >separating when that amount of stress is put on the engine. Anyways, I
> will
> >check that when I take it apart to change out the headgasket. If that
> >doesn't work, then I will just order an aluminum head from Moss and have
> the
> >bottom end rebuilt. Any suggestions are welcome.
> >Thanks
> >Michael Poe
> >1974 1/2 MGB GT
> >
|