At 03:53 PM 2/13/99 -0500, Bill Schooler wrote:
>.... replacing wire wheel hubs on a 1960 MGA. Started on the rear. The
axle half shaft came out when I removed the old hub extension and I'm
having mucho difficulty separating the two. Is this the norm? Is the hub
extension pressed on to the axle shaft? Or am I dealing with 39 year old
rust?
Uh, yup, pressed on. And in this case, a bigger hammer probably isn't
going to do it. Look for someone with a hydraulic press.
Barney Gaylord
1958 MGA with an attitude
|