I found the hole in the splined hub and used a sharp drift to push
them out. It took some hammering and sweating, but I finally got
them out. Once I did, I found that a layer of grease and sand was
holding them in. Now that the insides of the hubs are clean, the
grease cups slide out to the hub of the wheel and fall out when I
pull off the hob. Go figure!
Michael S. Lishego
http://www.geocities.com/MotorCity/Speedway/3706/
>Hey all!
>
>I'm stumped again. (Big surprise, eh?)
>
>My current problem: Those &^%#^#!!!! grease cups in the wire wheel
hub
>of my '70 B. How in the world are you supposed to get those
obstinate
>little buggers out of there????
>
>And I thought I was just going to do something simple like install
new
>rotors. Zheesh!
>
>
>
>Chris
>'72 B Roadster
>'70 B Roadster
>a VERY patient wife (xmas lights supposed to be up two days ago
now...)
>:)
>
|