Dont.
The gaskets should seal quite well without any added chemicals.
Plus, if you ever have to remove the intake, things come apart SO much
easier.
Rick Morrison
72 MGBGT
74 Midget
On Wed, 25 Nov 1998 13:45:44 +1000 "Neil Cotty" <neilc@tradesrv.com.au>
writes:
>Hi all,
>
>A quick question. I have replaced the one piece exhaust and inlet
>manifold
>gasket to block - dry - and are replacing the six carb/heat shield
>gaskets.
>I have been giving varying advice to use and not to use gasket
>sealant. What
>is the general consensus on this? Mine didn't have any form of sealant
>on
>them when I removed them. I'm not sure if these are the original
>gaskets but
>they look it to me.
>
>Cheers,
>Neil.
>--
>Neil Cotty - Sydney, Australia
>1970 MG B GT / 1959 MG A 1600 Mk1
>
>
|