I've been off the list for about a month while they were upgrading our =
communications system and then ridding it of numerous bugs.
I exchanged my OD speedo from my non-OD GT for a non-OD speedo from a =
lister a couple of months ago. The previous speedo had no angle drive on =
the speedo unit and worked fine except for erroneous readings. The cable =
made no noise. When I installed the "new" speedo, I broke the old speedo =
cable. I replaced the cable and the speedo works fine, but the new cable =
squawks like crazy. I called Moss and they said I needed an angle drive =
on the speedo, but apparently they are very difficult to find. I'm =
confused. The previous speedo cable didn't make any noise and everything =
is set up like before.
I'd like to get this resolved ASAP so that I can drive again before winter =
really sets in.
Thanks - Gary Davis
|