>Any suggestions on how to remove the flywheel bolts on a B engine?
The bolts
>are very flat, and whoever removed them in the past must have barely
gotten them
>out and now they are basically smooth. I could grind the heads off,
then remove
>them but I'm open to any and all suggestions.
>
>I have managed to get two of the six out.
Larry, go get yerself a welder and weld on a set of 1/2" square bar
stock to the tops of the flywheel bolts. Then go get your favorite
open-end wrench and go to town. Use some rust penetrant to help get
them out. I prefer GM Goodwrench stuff, but there are other good
brands out there.
Jay
|