Mike (or should I say Mikes.............?)
Sounds to me that Mike L. hit the nail on the head. Mike R's front carb is
flooding due to dirt under the needle in the float valve, or a just plain
defective float valve, or a punctured float (less likely with these brass
floats.)
So, what's the point of my post? A minor correction for Mike L., but one to
be noted by Mike R.............the float height on an H-type SU is set at
7/16", not 1/8". The latter is only for HS carbs with plastic floats.
Lawrie
-----Original Message-----
From: Leckstein <bleckstein@mail.monmouth.com>
To: Mike Razor <mrazor@kih.net>; mgs@autox.team.net <mgs@autox.team.net>
Date: Sunday, October 04, 1998 3:44 PM
Subject: Re: SU CARBS
>Mike, have you changed the needle and seat? Pulled out the float and shake
>it to see if it has a pin hole leak? Reset the fork to 1/8 clearence? If
>this doesn"t work, then follow the experts.
>
>Mike
>
|