Dear "Wisdom of the MG List"
I've just found out that I have an air leak in the vacuum advance line at
the small "canister". This is obviously not helping with my timing or
mixture settings.
A few questions. What is in this "canister", a check valve?, a simple
baffle? It obviously serves to prevent the gas mixture getting down to the
distributor but how? Can this be replaced with something else? There seems
to be a crack around where the tubing enters the canister, if I was to try
to repair this any suggestions, solder? epoxy? silicone?
I'm sure someone else out there has dealt with this. Thanks in advance for
any advice.
Kevin Mardell
|