I think just about any competent engine rebuilder can build a 1950 cc
engine,,,,,,,,, if you start with good block. I've even heard of
2000cc. I believe that because of variances in blocks some cannot be
bored that much.
Doesn't Doug Jackson have info on this on his web site? You might
check it out http://www.mgbmga.com/index.html.
Good luck.
Larry Hoy
Denver, CO. USA
1969 MGB Roadster
1987 Jaguar XJ6 VDP
"It's not how fast you go, it's how fast you go fast"
=========================================================
> -----Original Message-----
> From: owner-mgs@autox.team.net [mailto:owner-mgs@autox.team.net]On
> Behalf Of Kai Radicke
> Sent: Friday, August 28, 1998 8:28 PM
> To: MG List
> Subject: 1950cc engines suppliers in the USA
>
>
> I've seen quite a few advertisements in UK publications for
> these "ready to
> go" engines, but haven't found (well I didn't look real
> hard either) US
> suppliers.
>
> So if anyone is a supplier/builder of these engines please
> let me know :)
>
> That would be a 1950cc B series engine... just to clarify!
>
> chocks away,
>
> --
> Kai Radicke -- kai@autojumble.net
> IRC: irc.cs.cmu.edu, #inet-access
|