| To: | neil.cairns@virgin.net, gbaker@customcpu.com |
|---|---|
| Subject: | Re: Block Stampings |
| From: | AEKell@aol.com |
| Date: | Sun, 23 Aug 1998 09:20:30 EDT |
In a message dated 98-08-23 04:43:11 EDT, neil.cairns@virgin.net writes: << The bores were measured, and pistons graded,( by half-thousandths of an inch,) and often the grade was stamped on the lower face of the block, ( the sump, or pan >> Neil, Could the piston grade also be stamped on the upper face of the block? If so (or not), What would the number three mean? Alan |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Correction!! Re: Verifying and Adjusting Floats on Weber DGV, Larry Macy |
|---|---|
| Next by Date: | replacing axle seals and bearings, John77577 |
| Previous by Thread: | Block Stampings, Baker, G. |
| Next by Thread: | Re: Block Stampings, neil.cairns |
| Indexes: | [Date] [Thread] [Top] [All Lists] |