I had last Thursday and Friday off last week, so I thought I would
finally replace the clutch on my 72 B so I could drive it on the Fourth.
The clutch replacement went OK. I had a little trouble getting the motor
back in alone, but it wasn't too bad.
The problem is that now the car won't run for more than 30 seconds
before it dies. If I try to start it immediately after it kills, it
won't start. If I wait a minute while the fuel pump (non SU after
market) runs, it will start and run for about 30 seconds. It has to be a
fuel supply problem. At one point when it started to die I sprayed gas
into the carb and that kept it running. I pulled the fuel supply line
from the carb and it is putting out plenty of gas. The fuel filter is
only a month old and looks OK.
I have tried:
adjusting the floats
new float bowl valve (from Grose jet to original style)
new needles
new fuel pump
At this point I am at a loss. All I did to the carbs for the clutch swap
was to remove them and replace them. I didn't do anything to the pump.
If any of you have any suggestions I'll try anything at this point.
Please send reply's to my address as well as the list since I have just
started a new job and I'm way behind on reading the digests.
TIA
Fred
|