To: | MG mailing list <mgs@Autox.Team.Net> |
---|---|
Subject: | stud question |
From: | Tyson Sherman <tsherman@tecinfo.com> |
Date: | Wed, 17 Jun 1998 01:03:04 -0500 |
I was plastiguaging my main bearings today in my B, and when I was removing one of the nuts to the main bearing caps, a stud came out with the nut (along with some very smelly oil - not like regular motor oil). I separated them very easily and put it back together. I've never done anything like this. Can I just screw the stud in and tighten by hand, or do I need to get it tighter before I put the cap, washer, and nut on (and retorque)? -- Tyson Sherman http://www.tecinfo.com/~tsherman |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Springs, Gary A. Graham |
---|---|
Next by Date: | Re: cast iron manifold paint, Murray Arundell |
Previous by Thread: | Hat!, Frank R. Krajewski |
Next by Thread: | stud question -Reply, Matt Kulka |
Indexes: | [Date] [Thread] [Top] [All Lists] |