In a message dated 98-04-30 09:59:06 EDT, jkoster@ncpi.com writes:
<< Hello Everyone!
I am sorry if this question has already been asked but I don't understand
hydraulics systems. My slave cylinder does not return all the way back.
Is this ok? I haven't got to try out the clutch yet. After I replaced the
slave cylinder Pressure hose, I found that my linkage to the accelerator
came loose, now I am getting parts together to fix that, So while I was
waiting for that I was wondering
if My slave cylinder was functioning right. Thanks for the help in advance!
Joe Koster
71 MG Midget
jkoster@ncpi.com
>>
Joe,
The slave cylinder should return under the pressure of the pressure-plate
springs. The clevis pin should not be under any tension when the pedal is
released. At least this is how it works on my B and I assume it's the same
for you.
Tom
|