Did things work before you changed the slave cylinder? Or did you have the
same identical problem.
...Art
On Mon, 29 Dec 1997, Ron Madurski wrote:
>
> Here is what I have done so far. As a review I was having problems with
> the slave cylinder not disengaging the clutch. I cut up the plunger
> from the old slave cylinder to make up the slack in the mechanism.
>
> there were some suggestions on what to look for:
>
> Worn Pushrods - Bothe the master and slave pushrods are in good
> condition.
>
> Worn bushings - they all sem OK.
>
> One odd thing to me is that the clutch lever can be moved in and out
> about an inch. Is this bad?
>
> The clutch is acting strangely now. Once I fire up the engin I cannot
> get the car to go into gear. I can start it in gear and take it out of
> gear but it will not go back into gear. I am working on getting a
> slightly longer spacer in the slave as an adjustment but I don't hold a
> lot of hope for it.
>
> Any problems to be encountered when I end up pulling the engine to fix
> this properly?
>
>
> --
> Ron Madurski
> rmadursk@galaxy.galstar.com
>
|