In a message dated 97-12-27 13:27:18 EST, you write:
> will operate on 120 volts. Keep in mind, when running the electric for the
> compressor that the further you are from your power source, the greater the
> voltage loss will be at the motor, and low operating voltage on motors is
> not good, it will draw more amps than the rating tag. Make sure the wire
> you use is large enough for the distance you have to run, longer length
> requires larger wire for the amperage.
>
This is correct. The lower the voltage, the hotter an electric motor will run.
This is just the opposite of other electrical devices such as light bulbs.
Also, make sure you're using an adequate gauge wire for your automotive motors
to keep them from over heating.
Bob Donahue (Still stuck in the '50s)
EMAIL - BOBMGT@AOL.COM
52 MGTD - under DIY restoration NEMGTR #11470
71 MGB - AMGBA #96-12029, NAMGBR #7-3336
|