| To: | charlie@mars.ark.com, mgs@Autox.Team.Net |
|---|---|
| Subject: | Re: removing the u-joint |
| From: | MGBRAT97@aol.com |
| Date: | Sun, 23 Nov 1997 22:58:41 -0500 (EST) |
Charlie, I removed my column a while back, so my memory isn't precise... but I do remember removing the bolt and nut, and using a very small (1/4" wide) cold chisel to spread the joint just a bit - to release the pressure on the splines. Using a small pry bar the and the shaft should then slide off the joint. Let us know how you make out. Phil Collura '74 MGB |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Cheap Tools, RJohn50603 |
|---|---|
| Next by Date: | Off Topic!!, Tom Buchanan |
| Previous by Thread: | Re: removing the u-joint, Paul Hunt |
| Next by Thread: | Re: BRGreenhouse effect, pat bailey |
| Indexes: | [Date] [Thread] [Top] [All Lists] |