> The apparent ground (black) wire from the wind shield wiper / washer switch
> is loose. I cannot determine where it should attache to swiitch. The wire
> from the washer feeds up into the stalk. By the way the wipers work fine.
> The washer also works fine if I jump around the switch. Would just like to
> get it wired back correctly.
>
> Can the "knob" on the end of the stalk which you push in to make contackt
> be remove?
>
> I am able to get switch off steering column with no problem. Just can't
> see how to take apart without tearing it up. Any suggestions would be
> appreciated.
Just turn the little metal cap on the end of the wiper switch arm, it
will unscrew and in side there is a nylon piece that makes up the
contact part of the switch.
Hope this helps...
Chad
'72 B Daily Driver
|