To: | stritle@epix.net |
---|---|
Subject: | Re: valve clearance on TD |
From: | mgbob@juno.com (ROBERT G. HOWARD) |
Date: | Thu, 16 Oct 1997 06:52:08 EDT |
Hi Steve, Unless you get some authoritative advice, mine would be to set them at 019 cold and adjust again when hot. Bob On Wed, 15 Oct 1997 12:25:28 -0400 Steven Tritle <stritle@epix.net> writes: >Since my rocker assembly is being worked on what clearance should be >used to set the tappets when cold. I use .019 when hot. > >Steve >52 TD > |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: In re: 'For Sale' items, non-LBC content, etc..., dresden |
---|---|
Next by Date: | Re: 18V head studs, ROBERT G. HOWARD |
Previous by Thread: | valve clearance on TD, Steven Tritle |
Next by Thread: | 1500 Bottom End Rebuild, Adrian Jones |
Indexes: | [Date] [Thread] [Top] [All Lists] |