Steven Tritle wrote:
>
> Trmgafun@aol.com wrote:
> >
> > In a message dated 97-08-16 08:43:19 EDT, you write:
> >
> > << Checked the points and they were not opening all the way opened
> > them up and it still would not start, put a new coil on it and it fired
> > up until wife stalled it out backing it in the garage and it would not
> > start again. Timing? Spark? Fuel? >>
> >
> > Mike,
> >
> > When you say that you opened the points back up and it still would not
>start,
> > could you explain how you opened them back up? This might shed some light.
> > Are you setting the points to the proper gap, but then the gap changes?
> >
> > Scott Helms
> You may even have a loose distributor. Take the rotor off and take hold
> of the cam to see if you can move it. There should be no play in the
> distributor.
>
> Steve
> 52TD
|