In a message dated 2/19/97 11:39:36 AM, you wrote:
<<s an alternative to a new/used crankshaft pulley, I was contemplating
removing the remaining elastomer and filling the void with JB Weld. The
net effect of the change would be a one-piece pulley.
Will this destroy my engine? I assume the engineers put the damping
effect into the pulley for a good reason. Am I wasting my time and
engine?
>>
DO NOT TRY IT! It would come apart. The added weight of a front crank
pulley is to minimize crankshaft twist.
=========================================================
British Car Specialist 2060 N. Wilson Way Stockton Ca 95205
209-948-8767 (fax# 948-1030) HealeyDoc@aol.com
Technical books by Norman Nock avalable for the MG and Healey.
** Triumph Technical book by Norman Nock available very soon!
If you have any questions give Norman or David Nock a call
|