To: | russ@scubed.com (Russ Wilson) |
---|---|
Subject: | Re: TC oil leak seals |
From: | Bill Harkins <wharkns@inetworld.net> |
Date: | Fri, 13 Sep 1996 20:24:55 -0700 |
At 08:01 AM 9/13/96 -0800, you wrote: > I asked if these failures had used the oil sleeve on the crank that Al recommends, but does >not supply as part of his kit. I have not pulled the engine yet to do the seal job, but I have the parts. I am hoping to supercharge (Marshall) this winter and will pull the engine for full rebuild including the seals. Good point about the oil sleeve. Bill Harkins |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Nitrious oxide, Gregg Baker |
---|---|
Next by Date: | RE: Fwd: Copper/Steel/Aluminum Lines, John W. Dean |
Previous by Thread: | Nitrious oxide, Gregg Baker |
Next by Thread: | OD installation, fuzzy |
Indexes: | [Date] [Thread] [Top] [All Lists] |