S. L. Hower wrote:
[misc deleted]
> When I dropped my engine bits off at the machine shop, the
> machinist asked me about a squillion questions: Hottank?
> Shotpeen? Nitriding? Knife-edge? Align-bore? I was doing
> fine, until me asked if I wanted the crank 'indexed' when
> they reground it.
[misc deleted]
> I trusted this shop, however I learned a valuable lesson that
> day; if you dont understand, swallow your pride and *ask*.
>
Ok, pride swallowed:
I know a little about align boring/shot peening/etc. but what is
nitriding and knife-edge?
--
Jeffrey Fayne - Systems Engineer fayne@mcs.com
INX International Ink Co. http://www.inxink.com
1130 Howard St. Elk Grove Village,IL 60007
(847)364-7774 x23 (847)364-7825 FAX
|