I am in the process of getting my 78 MGB on the road. I rebuild the
master clutch cly. last night and bleed it. When I push the clutch
pedal in I feel no resistance for the first 1/2 to 2/3 of the way
then ressistance at the bottom end of movement. But the clutch dosnt
disengage. I looked underneth while someone else pused the clutch in
and can see the slave move about 1 inch. Is this as far as it moves
or should it move farther? Could the clutch be seezed? The car as
been sitting for 5 years. thanx for any advice. Also can I pull the
tranny on a 78 without pulling the engien? I can see that the
crossmembers are bolted on not welded. Will this alow you to pull the
tranny? Thanx!
Keith
78 MGB
____________________________________________________________________
"The first ten million years were the worst and the second ten million,
they were the worst too. The third ten million I didnt enjoy at all. After
that I went into a bit of a decline."
- Marvin reflecting back on his 576,000,003,579 year career as Milliways' car
park attendent.
Keith Fisher Fisherk@GAS.UUG.ARIZONA.EDU
___________________________________________________________________
|