Hi,
I need to carry out some minor rust removal on my 72 Midget.
Since this will be my first time doing body- and paintwork
I am slightly at a loss as which primer to use.
I though of using hamerite for the places which will be
covered by underbody seal, since someone told me that this
gives the best protection if I don't have to spray it over.
But which primer should I use for the visible places which will be
sprayed over?
I saw some rust eaters which work as primers too. I was wondering
if this will give additional rust protection just in case some
microblisters of rust remain after wirebrushing.
or should I use a zinc primer (the heritage bodyshells have a
zinc primed underbody and if it works well for them ...)?
or what about these "two pack" or epoxy primers someone mentioned
on the MG mailing list ?
Any comments/suggestions greatly appreciated ...
Eric
|