Have replaced the clutch plate and carbon bearing that actuates the =
clutch pressure plate, put the proper grease on that came with the =
clutch plate, and now it is back in the car there is not enough clutch =
movement,
The clutch pedal is very soft, I checked the slave cylinder seems OK, am =
now going to replace the master cylinder complete (enough fooling =
around).
But I still have this nagging question about how much pressure should be =
required to actuate the clutch When I try and move the fork lever it =
is extremly hard.=20
Anyone know if this is right or has come across this same thing?
I dread taking the engine out again, even though I don't think I put =
anything in wrong the first time.
|