The bushings are not hard replace. You will have to remove the spring
but replacing it is not difficult if you use a floor jack.
Remove the split pins holding big arm nuts in place, then remove the nuts
The a-arms can then be removed, old bushes pushed out if they don't fall
out, and neew ones put in. Put some wheel bearing grease around the new
bushes and coat the inside of the a-arm before installing new bushes.
By teh way remove teh coil spring before removing the a-arm or you might
get you nostrils cleaned out by the a-arm pan slapping you up side the
head.
As a note: check out getting a factory manuel from one of teh mail order
houses or check out you local British sporty car repair shop for an after
market repair manual. They really help.
George Curl 64 B DSP
|