Dave,
>Go to your local hardware store and by two "C"
>clips, the ones with the little holes ( I don't know the exact name, so
maybe
>I'm not helping here) Borrow or buy a pair of the special plyers with the
>interchangeable tips that streach the C clip. You will also need a spacing
>washer to put between the wheel cylinder and the backing plate because the C
>clip with the holes in them are thinner than the ones supplyed. It takes
>about 15 seconds to do it this way, and the wheel cylinders move about far
>less.
I had to do the same about a month ago. They are called external snap rings.
I can't remember the exact size ( I took a cylinder with me to get the best
fit). They might have been 5/8", I'm not sure.
R. Johnson - Dallas
|