This probably won't help much....but did you rebuild the cold start
valve when you put the new needles in the carbs?
My B (18V-twin SU's) ran horribly even though I had the float levels
correct......
Wait a second.....from memory you said you had the float levels at 1/8
inch... That is .125" .....isn't the float gap supposed to be .04"-.05"
which would be just under 1/16 (.0625")
Jeez, maybe thats your problem.....
Back to the cold start valve.....mine ran horribly until the o-ring was
replaced....it was a goner.
I need to start making sense
Merry Christmas
Eric
Eric L. Van Iderstine - ME senior - Mississippi State University
Design Coordinator - MSU Formula SAE......Powered by Honda......
elv1@Ra.MsState.Edu http://www2.msstate.edu/~elv1
74 MGB - 85 Buick LaSabre - 95 DiamondBack Sorrento
|