On Mon, 4 Dec 1995, A. B. Bonds wrote:
> You can get a set of lifters for about $35. Note that the success of
> this replacment will depend heavily on the state of your cam. If the
> cam is not in good shape, the rattle will come back fairly quickly.
> You can also reduce top end noise by getting your rockers rebuilt.
> See Rocker Arm Specialists in the monster vendor list. They did mine
> last year for $85. A beatiful job, took about two weeks (new
> bushings, grind the shaft and resurface).
> A. B. Bonds
>
Check out Datsun/Nissan truck rockers and shaft. I order a shaft for my
B about a year ago and it came in a nissan package. I was going to
rebush my rockers but through some investigation by a mechanic friend I
found they were the same as a ? B1800 truck rocker. I ordered 8 of these
at about $10 cdn (<$8 US). They matched perfectly, and saved me a lot
of $$$$ over rebuilding/new.
Gary
MasterClk__| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_| |_|
__:___:___:___:___:___:___:___:___:___:___:___:___:___:___:___:
Character__|20_|47_|61_|72_|79_|20_|42_|75_|72_|72_|65_|6C_|6C_|20_|20_|
:_______________: : :
FirstName______| |___:___________________________:________
: __________________________:
Surname __________________________| |________
Electronic Signature: Gary R. Burrell P.Eng. (burrelgr@tuns.ca)
Try my new home page (http://www.tuns.ca/~burrelgr)
|