This is all so I can pass emissions in Colorado...
I'm experiencing problems in finding a bushing to hold a pipe into a
threaded hole normally used for the EGR valve connection into the exhaust
manifold on the 1500cc engine.
The machine shop removed a piece of threaded "something" that had been
filled in with welding to prevent exhaust gases from leaking out.
Anyway, they said it was 3/4 inch, 14 threads per inch. Is this
available anywhere stateside???
Secondly I need to find some kind of heat proof pipe to go from this
junction in the manifold to an air pump inconveniently mounted on the
opposite side of the engine.
All suggestions would be greatly appreciated,
Nick D. Benson
Dept. of Industrial Sciences
Colorado State University
Fort Collins CO
|