Barrie: the filter caps are not needed. A noisy circuit is ok in this
applacation. The gauges don't care.
Jim Miller
Sent from my iPod
On Nov 28, 2008, at 4:26 PM, Barrie Robinson <barrie@look.ca> wrote:
As a result of reading "How to replace your MGB's Thermal Voltage Stabiliser"
from the British V8 Magazine, I delved into the subject - well, I had no beer,
there was snow on the ground, the Maserati would not start, the jet was being
serviced........and my butler and cook had the day off, so can you blame me?
It would seem that the circuit as described in the article is a bit short and
would be subject to erratic behaviour under certain circumstances. My circuit
has double bypass filters using both electrolytic and ceramic capacitors. The
components are so damn cheap so overkill is not a problem. However, I have to
make a unit to fit inside the original casing and I do not have a spare close
by. Can anyone give me the inside dimensions of the casing please?. Or, if
anyone has a dud one I would gladly give you a couple of dollars, plus postage,
for it.
Regards
Barrie
Barrie Robinson
(705) 721-9060
http://www.britishv8.org/MG/BarrieRobinson.htm
http://www.britcot.com _______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgb-v8 mailing list
You are subscribed as v8mgb@yahoo.com
Mgb-v8@autox.team.net
http://autox.team.net/mailman/listinfo/mgb-v8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgb-v8 mailing list
Mgb-v8@autox.team.net
http://autox.team.net/mailman/listinfo/mgb-v8
|