According to my Haynes the oil pump is at the back of the gearbox below and
slightly forward of the output flange. The manual shows the oil pump being
removed only after the rear cover has been removed, which looks like it can
only be done after removal of the remote control housing, output flange,
speedo drive, and '5th gear selector spool locating boss'. Pity it doesn't
give an output pressure for the pump, or you could put your mind at rest. Or
alternatively start planning a strip-down.
PaulH.
----- Original Message -----
From: Barrie Robinson
To: mgb-v8@autox.team.net
Sent: Wednesday, September 10, 2008 3:53 PM
Subject: [Mgb-v8] SD1 gearbox oil pump
I looked in the archives and found my question in the mode "Can you
change the oil pump bits in the SD1 gearbox easily or do you have to
drop the box?" But I cannot fins any answers.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgb-v8 mailing list
Mgb-v8@autox.team.net
http://autox.team.net/mailman/listinfo/mgb-v8
|