mgb-v8
[Top] [All Lists]

Edelbrock intake manifold

To: mgb-v8@autox.team.net
Subject: Edelbrock intake manifold
From: Barrie Robinson <barrier@bconnex.net>
Date: Mon, 17 May 2004 19:59:38 -0700
Reply-to: Barrie Robinson <barrier@bconnex.net>
Sender: owner-mgb-v8@autox.team.net
The Edelbrock manifold 2198 has a rear hole to which one must bolt an adapter to take off a rubber hose to the heater. I have been unable to locate a supplier of such a beauty so I have to make one. My MGB GT V8 in-the-making is not accessible so I am hoping that someone has the measurements of the two bolt holes. Edelbrock have not responded for information!

Can anyone help please? Thank you advance for any replies

Regards
Barrie

Barrie Robinson
barrier@bconnex.net
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///


<Prev in Thread] Current Thread [Next in Thread>