| To: | mgb-v8@autox.team.net |
|---|---|
| Subject: | Re:Ford 302 questions |
| From: | MGV8VT@aol.com |
| Date: | Fri, 20 Feb 2004 07:15:42 EST |
| Reply-to: | MGV8VT@aol.com |
| Sender: | owner-mgb-v8@autox.team.net |
Unless you have bushed rods you will have to stay with a press fit
setup. Hopefully the shop you use has a rod oven for installation. You must
also
run a larger top ring gap with KB pistons, as per their instructions.
Dale
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Ford 302 questions, T. S. White |
|---|---|
| Next by Date: | TR8/SD1 throwout bearing?, kmwheeler |
| Previous by Thread: | Re: Ford 302 questions, Paul Hunt \(T\) |
| Next by Thread: | TR8/SD1 throwout bearing?, kmwheeler |
| Indexes: | [Date] [Thread] [Top] [All Lists] |