25 degrees? Holey Crow!! What is it now? I think 2 to 4 degrees is in
the zone? I'm trying to calculate the geometry for my 4-link rear-end and I
figure I can't weld any brackets on the axle until I get the motor/tranny in
for the same reasons.
James J.
-------Original Message-------
From: kdad@ezl.com
Date: Tuesday, July 01, 2003 10:37:29 AM
To: mgb-v8@autox.team.net
Subject: Drive train vibration.
I found and fixed my drive train vibration. My front verticle pinion angle
was too great, 25 degrees. I spaced down the tranny, and raised the front
of my motor slightly and it is gone. I also replaced the yoke and had the
drive shaft rebalanced. Finally time to get some driving in.
Arlie
[demime 0.99d.1 removed an attachment of type image/gif which had a name of
IMSTP.gif]
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|