James,
I found some of the torque settings you require in a "Haynes" manual for the
Rover 3500 1968 to 1976 loaned to me by my engine re-builder.
cylinder head bolts: 65-70 lbs/ft
Main bearing cap bolts (one to four): 50-55
Rear main bearing cap: 65-70
Big-end bearing cap: 40
Rocker shaft: 25-30
Flywheel: 50-60
Inlet manifold: 25-30
Inlet manifold clamps: 10-15
Exhaust manifold: 10-15
For some reason, it doesn't list the con-rods. Maybe someone else on the
forum has them as well as confirm the above values.
I do have others listed here for ancillaries if you need them.
Hope this helps.
Simon Austin
>Hi,
> Anyone know where I can find the torque values for rebuilding the
>215/3.5 (values for mains bolts, con-rods, heads, not engine torque)?
> Hardcastle's book only shows a few values here and there.
>James Jewell
_________________________________________________________________
MSN Photos is the easiest way to share and print your photos:
http://photos.msn.com/support/worldwide.aspx
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|