DOH! I hate it when I forget things like that. Is probably why I have
resorted to having lists for everything I do. Is also why my progress pages
are so wordy, I am using them as my diary so I don't forget what I have
done.
I have my new 2.5" driveshaft and it fit perfectly. I was NOT pleased to
say the least when I found out that the 3" would not work, especially after
I dropped $200 to have it made up. My V8 is finally getting very close to
being done. with any luck it should be running in the next week or two. I
just need to solev my clutch system problems and she will be ready for road
test. I hope to run in the cam late this week and have the engine all ready
to go when my new fuel pump lands later this week.
Larry
----- Original Message -----
From: "Larry Hoy" <larryhoy@prodigy.net>
To: "MG V8 List" <mgb-v8@autox.team.net>
Sent: Sunday, April 07, 2002 1:13 AM
Subject: FW: V8 Driveshafts
> I'm forwarding this to the list, Larry E forgot to clip the trailer and
> it went to Marks cyber trash can.
>
> Larry Hoy
>
> -----Original Message-----
> From: Larry E [mailto:Larry@embreyfamily.com]
> Sent: Saturday, April 06, 2002 7:28 PM
> To: Larry Hoy; MG V8 List; 'Chris Jones'; Al Wulf; James Nazarian; Bill
> & Glenda Dudley
> Subject: Re: V8 Driveshafts
>
>
> I speak from experience. 2.5" is the largest that will fit. I just had
> to pay to have my driveshaft redone, as the 3" donor shaft I uses was
> too big. it will fit in the tunnel, but not once ton connect to tranny
> and rear axle.
>
> More updates on the website.. tech section then.
> Larry
> www.embreyfamily.com/mgb
>
>
> ----- Original Message -----
> From: "Larry Hoy" <larryhoy@prodigy.net>
>
> > FYI. I was asked what is the largest diameter drive shaft can you use
> > on the MG. I'm not sure the max diameter, but mine is 2.5".
> >
> > Larry Hoy
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|