mgb-v8
[Top] [All Lists]

Re: Tranmission Tunnel

To: brucemills@dccnet.com
Subject: Re: Tranmission Tunnel
From: "J MILLER" <road1978@hotmail.com>
Date: Sat, 09 Dec 2000 13:44:03 -0500
Cc: mgb-v8@autox.team.net
Reply-to: "J MILLER" <road1978@hotmail.com>
Sender: owner-mgb-v8@autox.team.net
I did the trial and error method.  Attached is a picture of the area that I 
made adjustments to.  I don't believe this picture was the final form but 
will give you an idea.  The motor mounts also need to as low as possible to 
keep the transmission low.

Jim Miller
www.geocities.com/v8mgb


----Original Message Follows----
From: "Bruce" <brucemills@dccnet.com>
Reply-To: "Bruce" <brucemills@dccnet.com>
To: <mgb-v8@autox.team.net>
Subject: Tranmission Tunnel
Date: Fri, 8 Dec 2000 21:19:42 -0800

With regards to my 74 1/2 MGB/Rover 3.5/Camero T5 tranny/MGB conversion. I
have beaten up the transmission tunnel so that the front tranny seam is on a
higher plane than the next structural member. Which is the one where the
radio structural support is directly above. The question I have is how much
does the seam have to be beaten up to fit the T5?

Thanks in advance

Bruce

_____________________________________________________________________________________

[demime 0.97c removed an attachment of type image/pjpeg which had a name of 
MGtunnel.jpg]

<Prev in Thread] Current Thread [Next in Thread>