| To: | awulf@bewellnet.com |
|---|---|
| Subject: | Re: Replacing the Seal on bottom of Windshield assembly |
| From: | renaud <renaud@mail.oeonline.com> |
| Date: | Sat, 08 Jul 2000 22:00:36 -0400 |
| Cc: | mgb-v8@autox.team.net |
| References: | <200007071801.MAA21044@teamfat2.dsl.aros.net> |
| Reply-to: | renaud <renaud@mail.oeonline.com> |
| Sender: | owner-mgb-v8@autox.team.net |
Hi, Al, I installed the seal on my 79 mgb in the curled position and then used a plastic bondo spreader (about 4 in.wide) to push out the curl from the inside of the windshield. It went very well! :-) Hope it works for you! Regards, Jack Renaud awulf@bewellnet.com wrote:Is there an easy way to replace the seal (Moss Part no. 282-410)page 69 of the MGB catalog? |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Looking for Rover engine?, Barrie Robinson |
|---|---|
| Next by Date: | Rear end ratios, Larry Hoy |
| Previous by Thread: | Replacing the Seal on bottom of Windshield assembly, awulf |
| Next by Thread: | RE: Replacing the Seal on bottom of Windshield assembly, Robicheau, Mike |
| Indexes: | [Date] [Thread] [Top] [All Lists] |