It looks like the typical gasket to me - and I recently had a genuine MOWOG
gasket in my garage. I haven't heard about any gasket failure between
cylinders as being typical, but I suppose it might happen if the mating
surfaces aren't properly prepared.
There are two head gaskets for the XPAG, one with round holes for round water
passages and one with the irregular oblong holes for oblong water passages.
The photo shows the correct combination.
Cheers,
-Mike Eldred
Wilmington, VT
> Date: Mon, 6 Oct 2014 19:05:32 -0600
> From: mark@bradakis.com
> To: mg-t@autox.team.net
> Subject: [Mg-t] TC Head gasket
>
> I've been asking some gasket experts about this, thought some of you folks
might be interested as well.
> Check out
>
> http://www.team.net/forums/viewtopic.php?f=8&t=176
>
>
> mjb.
> ______________________________________________
>
> Mg-t@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/mg-t/redscirocco@hotmail.com
______________________________________________
Mg-t@autox.team.net
Archive: http://www.team.net/archive
|