Re: [Mg-t] XPAG valve clearance

[Bud Krueger <budkrueger@comcast.net>]

What camshaft is in the engine?

Bud
Richard Lindsay wrote:
> Hi Friends,
>
> Please share your thoughts on valve clearance of a cold XPAG/TD2 engine.
>   In short, what I am wondering is what clearance I should use on a freshly
> rebuilt engine, to get it hot enough to do a proper HOT engine valve
> clearance setting.  I believe the hot clearance on the later engines is
> 0.012" so I'm guessing that 0.018" or so cold, would be fine for the
> initial warm-up.  I'd much rather suffer valve chatter for a few minutes,
> than have the clearance close up due to linear expansion.  Your thoughts?
>
> -rick
>
> PS: No, I'm nowhere near that point.  Its just a question dancing around in
> my scattered mind this morning...
> ______________________________________________
>
> Mg-t@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/mg-t/budkrueger@comcast.net
______________________________________________

Mg-t@autox.team.net
Archive: http://www.team.net/archive