APT Instruments (Charles)
9632 Humbolt Ave. So.
Bloomington, MN 55431
952-881-7095
MO-MA
1321 2nd St. N.W.
Albuquerque, N.M.
505-766-6661
momanm@qwest.net
Nisonger Instrument
570 Mamaroneck Ave.
Mamaroneck, N.Y.
914-381-1952
West Valley Instruments
19314 Van Owen Blvd.
Reseda, CA 91335
818-758-9500
Vintage Restorations - John Marks
The Old Bakery, Windmill Street,
Turnbridge Wells, Kent,
England TN2 4UU
011-44-1892-525899
instruments@vintagerestorations.com
You could just plug off the opening. It is 3/8" british standard pipe
parallel.
Or, a MGB combo gauge will work.
John Seim
Irvine, CA
On Jun 29, 2008, at 5:58 PM, Mike Eldred wrote:
> The temp gauge in my 1954 TF 1250 isn't working - I know I'll have to
> send it
> out to be repaired, but does anyone have any thoughts on a temporary
> guage
> solution? I don't want to have to deadline it while the gauge is out.
> I was
> thinking of getting an aftermarket electrical gauge and sending unit
> for a
> temporary setup, but I'm not sure what might fit.
>
> Also, any recommendations on where to send the original unit for
> repair?
>
> Cheers,
> -Mike Eldred
> Wilmington, VT
>
> _________________________________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Mg-t@autox.team.net
> http://autox.team.net/mailman/listinfo/mg-t
>
> Archives at http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t
Archives at http://www.team.net/archive
|